|
-
Design and Fabrication of
Integrated Laboratory Station
A new, modern Integrated Laboratory Station is designed and
fabricated which incorporates modern developments in
instrumentation and experimentation, utilizing computerized
data acquisition (DAQ) and LabVIEW with signal conditioning (SCXI).
-
Masters’ Thesis
[PPT]
Finite Element
Simulation of Flow of Polymer in an Extruder Die - A
three dimensional flow and heat transfer simulation of
polystyrene in an extruder die and the free surface
deformations with swelling after the die is studied and
analyzed using Polyflow with an objective to improve accuracy
of extrudate dimensions.
-
Design of extruder dies for
Fermi Lab
Two dies are designed for Fermi Lab to extrude scintillated
plastics with the required extrudate shapes of rectangular
cross section with one hole and rectangular cross section with
ten holes.
- Design of a U-profile
die
A die is designed
for Technology Department, Illinois state University to
extrude Styron with the required extrudate shape of U-profile.
- Stress Analysis on
Crane Hook
The stresses in the
various parts of crane hook due to the applied load are
analyzed and the optimum dimensions to support the required
load are obtained using Pro-Mechanica.
-
Design of Function Generator
A layout for the synthesis of a four-bar function generator
based on freudenstein equations is developed in Pro/E such
that the program calculates the required lengths of the
coupler and follower for any given length of the crank, input
and output angles.
-
Developing Flows through Square Duct
The entrance flow
and heat transfer of Newtonian fluids through a square duct is
studied and analyzed using Polyflow to validate the efficiency
and accuracy of the software.
- A
study on Phase Change Problems:
The rate of change of phase of water due to heating or cooling
is calculated theoretically and analyzed using Fluent.
-
Design and Analysis of Centrifugal Pump:
The optimum dimensions of the centrifugal pump are calculated
and the pump is designed according to the given specifications
for NFCL, India.
|
 | |
|
